OPERATING EUROLCEAN STEEM
• Press the ON/OFF switch located on the handle to switch the steam cleaner on. The
red power ON light should now be illuminated. The steam generator will start to heat
but no steam will be emitted.
• Press the steam switch to the ON position. After about 30 seconds, when the steam
generator is up to the required temperature, the water pump will start, the green steam
ready light will illuminate and steam will be emitted.
• To stop the steam, switch either switch to the OFF position. For quick breaks, we
suggest just switching OFF the steam switch.
• After switching the cleaner to OFF, steam will continue to be emitted for a few seconds
until the steam generator is empty.
•
Turn the variable steam setting control to maximum and point the steam nozzle towards a cloth or sink for approximately
30 seconds, to stabilise the flow and produce a continuous steam.
DUAL FUNCTIONALITY
Your steam cleaner can easily be configured into two different cleaning modes:
•
Upright steaming for floors and carpets.
•
Attachment mode for vertical or hard to reach surfaces.
Important
:
Ensure the steam switch is turned off before connecting the floor head or any of the
other cleaning accessories.
UPRIGHT STEAMING: ASSEMBLY
Depending upon the task, connect the required floor cloth to the floor head by using the towel grips
as shown in this section.
To fit the nozzle to the main body, align the hole in the nozzle with the lock button on the main body.
Press the lock in and then twist and push the nozzle fully on until the lock button clicks into place.
10
Upright steaming
Attachment mode
Summary of Contents for Euroclean Steem
Page 23: ...20...
