EUM/OPS/MAN/13/730927
v3F e-signed, 15 April 2016
Ayecka SR1 DVB Receiver EUMETCast Setup Guide
Page 31 of 36
Satellite link. Packets
distained to the CPU
air IP address will be
delivered ONLY to the
CPU and not forwarded
to the LAN.
I
Air Ethernet Address
CC-F6-7A-04-
CA-B8
J
Isolate Networks
Allow connecting or
isolating the LAN and
Management networks.
Isolation is done in the
internal switch.
Isolated
Setting that
parameter to
“Isolated”
multicast packets
will come out
only to Traffic
port
Setting that
parameter to
“Connected”
mode, both
TRAFFIC and
Management
ports can be used
for data
reception and
MGMT
9.2
Scenarios
In order to allow the Tellicast client application to receive the data packets from SR1 the traffic LAN port of
the SR1 must be connected to the reception host –default setting- ( J
Isolate Networks
Isolated) or the
management port of the SR1 (J
Isolate Networks
Connected).This connection can be direct (by connecting
the reception host to the receiver using a LAN cable) or indirect (using a switch, router, joining a multicasting
network...), this leads to different network scenarios that can be adopted and consequently different SR1
configurations, the reception host network interface and Tellicast’s
recv.ini
must be correctly configured, in the
section below the most common network scenarios with the related needed configurations are described.
Please be informed that we cannot describe all the possible scenarios and that some scenarios may be very
complex which require that you contact a networking expert to assist you to operate the receiver.
