40 - Legend 548 Assembly and User Manual
30068-02A
The Tanning Session
(Operation as a stand-alone unit or con-
nected to a remote system using a control
relay. If using T-Max® see right.)
Lift the canopy, lie down on the bench
1.
(face up), lower the canopy toward your
body using the canopy handle. For best
results, position the canopy as close to
your body as possible.
Put on your safety goggles.
2.
Press the START/TIME button (C) to be-
3.
gin the tanning session. The lamps will
turn on and the timer will begin to count
down from the maximum time. If a less-
er time is preferred, repeatedly press
the START/TIME button to decrease the
time.
When the timer reaches “0” the lamps
4.
turn off. If you want to stop your ses-
sion before time expires, press the STOP
button (B). You will have ten seconds to
restart with the remaining time, other-
wise the timer will enter the cool-down
mode.
Raise the canopy by using the canopy
5.
handle, do not push up on the acrylic
shield. The cooling fans run for 5 minutes
after the lamps shut off to aid in cooling
the sunbed. During this time the display
will repeatedly
fl
ash “COOL” and then
the remaining cool-down time.
After cool-down the timer display re-
6.
turns to “0”.
(Operation while connected to a T-Max®
remote system. If using other remotes or no
remote system, see left.)
Lift the canopy, lie down on the bench
1.
(face up), lower the canopy toward your
body using the canopy handle. For best
results, position the canopy as close to
your body as possible.
Put on your safety goggles.
2.
Assuming the remote system has been
3.
set to allow a pre-tanning delay time,
the timer display (A) will repeatedly
fl
ash
“DEL” and then the remaining delay
time. Press the START/TIME button (C)
or wait until the delay time has expired
to begin the tanning session. The lamps
will turn on and the timer will begin to
count down.
When the timer reaches “0” the lamps
4.
turn off. If you want to stop your ses-
sion before time expires, press the STOP
button (B). The timer display will blink
and continue to count down. Press the
START/TIME button (C) to restart your
session.
Raise the canopy by using the canopy
5.
handle, do not push up on the acrylic
shield. The cooling fans run for 5 min-
utes after the lamps shut off to aid in
cooling the sunbed. The timer will in-
dicate “DRTY” as a reminder to clean
the sunbed. After the sunbed is cleaned
press the START/TIME button and the
display will return to “0”.
