28937-01A
20
Care and Maintenance - Lamp and Acrylic Replacement
Lamp and Acrylic Replacement
Introduction
To be assured of maximum tanning effec-
tiveness, change 100W lamps after
approximately 800-1000 hours of use.
Change 160W lamps after 600-800 hours
of use. Tanning will continue after this time
but at a slower rate. To ensure trouble-free
operation of your sunbed, replace the
lamp starters whenever the lamps are
replaced.
Maintenance Height Feature
The SOLARIS® offers a convenience fea-
ture when maintenance must be per-
formed. Behind the front access panel is a
release handle (see
Final Adjustments
).
With the canopy open, pull this handle and
the canopy will raise to its maintenance
position, allowing easier access to lamps,
etc. When finished, simply close the
canopy to return to normal operation.
Opening/Replacing Acrylic Shields
Refer to the illustration on the next page
while reading this instruction. The acrylic
shields in the bench and canopy are
secured in place with quarter turn latches
along the front edge. Use a flat-bladed
screwdriver or coin to turn the latches a
quarter turn to open the acrylic. The alu-
minum frame around the acrylic offers
support as well as allowing the acrylic to
hinge open without removing it from the
bed. On the inside of the bench, along the
front, are two supports for the bench
acrylic. Release them from their clips and
swing up to hold the acrylic open. You
may remove the acrylics by lifting them
out of the hinge channel along the back
edge.
When you are finished, simply reverse the
above directions to secure the acrylic
shields.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.