28937-01A
13
Installation - Remote Connections
NOTE: A T-Max® 1A with a
“master” chip can be substituted
for a 3A.
Scenario 1 - T-Max® Manager Series with Complete Wireless
Connect one G2 (with Power
Injector) to the Manager and one
G2 to each of the tanning beds.
Install as many beds as you like
with this configuration. Units that do not
communicate with T-Max will need a G2
with Power Injector and an additional
3A to operate. If you have an older T-Max®
Manager that doesn’t support auto addressing,
set the address of each sunbed manually as
described in
Setting the address manually
. You
can place your sunbed at any location in the series.
Scenario 2 - T-Max 3A with Wireless
In single sunbed installations, the T-Max® 1A and 3A can offer the
same control as the T-Max® Manager, eliminating the need for a
Manager. If you’re using a 1A in this manner, it must have a chip
labelled “master” installed on its circuit board. The remote control
bypass plug must not be used in this configuration. The 3A may be
used as a “master” with no modification.
After you have set the T-Max® 1A’s, or 3A’s, address to “0” (refer to
your T-Max® user’s guide) and the sunbed’s address to “1”, simply
connect one G2 (with Power Injector) to the T-Max® 3A and one G2
to the tanning bed.
Scenario 3 - T-Max® Manager
Series with Wireless combo
Connect one G2 (with Power
Injector) to the Manager and one
G2 to a wireless ready tanning bed. The
rest of the salon may be “daisy-chained”
together and connected to the wireless
equipped tanning bed, eliminating the need to
wire the Manager to the tanning beds.