MODEL 2081 TURNTABLE SERIES
Operation
© ETS-LINDGREN L.P. – JANUARY 2003
19
REV D – PN 399212
SETTING TRAVEL LIMITS
The mechanical limits of the Model 2081 turntable have been
changed from previous models for user convenience, ease of
operation and safety. These limit adjustments are located outside
the center section of the turntable adjacent to the gearbox. In some
installations, it will be necessary to remove several of the top
sections of the turntable to access the limit switch adjustments.
To increase the amount of travel in either direction turn the knob in
the direction indicated by the positive (+) sign. To decrease the
amount of travel in either direction you must turn the knob in the
minus (-) direction as indicated.
WARNING
Ensure the current ravel limit settings will not cause
damage to existing cables and equipment located underneath the
turntable.
You may decide not to use any mechanical limits if you want the
turntable to rotate continuously. To do this, the coupling between
the encoder and threaded shaft must be disengaged. To gain access,
remove the knobs and cover to the encoder. Disengage one side of
the coupling by loosening the set screws that link it to the shaft.
Then slide the coupling ¼ inch on the shaft to disengage the teeth
and retighten the shaft set screws.
CAUTION
The limits should be set whether or not the soft limits
present in the controller are used. Failure to do so may cause
damage to occur due to overrun of the table in either direction.
Once limits have been set, return the turntable to its original
position by replacing the top center section removed previously.
Archived 3/18/10
