Eton VIPER 70, Service Manual, Page: 91 / 122

INSTALLATION OF TIE-ROD
Install the ball joint with “ L” mark on the
steering shaft side.
Install the tie-rod with the mark on the wheel side.
Let the distance between the ball joints be 164 mm
for RXL 50/70/90 and RXL90R and RXL50M.
This is temporary setting.
INSTALLATION OF KINGPIN
Use grease to the kingpin lower dust seal lips
and install it.
Pump grease to bushing and install the kingpin.
Tighten the kingpin nut,
the setting torque is 30-40 N.m. Fix the waterproof
rubber cap.
Temporarily, set the distance 147mm between the ball joints.
Install the tie-rod and tighten the nuts.
The setting torque: 35-43 N.m
Install the front brake.
Install the front wheel.
Adjust the toe in. (see chapter 2)