EW50 Industrial LTE Cellular Gateway
233
SNMP Setting
Go to
Administration > Configure & Manage > SNMP
tab.
The SNMP tab allows user to configure SNMP relevant settings, including interface, version, access control and
trap receiver.
Enable SNMP
SNMP
Item
Value setting
Description
SNMP Enable
1. Boxes are
unchecked by default
Select the interface for the SNMP and enable SNMP functions.
When
LAN
box is checked, it will activate SNMP functions and you can access
SNMP from LAN side;
When
WAN
box is checked, it will activate SNMP functions and you can access
SNMP from WAN side.
WAN Interface
1. Required setting
2. ALL WANs
is
selected by default
Specify the WAN interface that a remote SNMP host can use to access the
device.
By default,
All WANs
is selected, and there is no limitation for the WAN
interface.
Supported Versions
1. Required setting
2. The boxes are
unchecked by default
Select the version for the SNMP
When
v1
box is checked, you can access SNMP version 1.
When
v2
box is checked, you can access SNMP version 2.
When
v3
box is checked, you can access SNMP version 3.
Remote Aceess IP
1. String format: any
IPv4 address
2. An optional item.
Specify the
Remote Access IP
for WAN.
Select
Specific IP Address
, and enter an IP address. Only this IP address can
access SNMP from LAN/WAN side.
Select
IP Range
, and fill in a range of IP addresses. It means the IP addresses
within the specified range can access SNMP from LAN/WAN side.
If left blank, it means any IP address can access SNMP from WAN side.
SNMP Port
1. String format: any
port number
2. The default SNMP
Specify the
SNMP Port
.
Enter any port number. But you must ensure the port number is not to be used.
Value Range
: 1 ~ 65535.