Below is an example diagram of how to use
RMS-200
with a shunt to measure charging from
a solar panel array. The negative solar panel lead is connected to the battery negative
terminal. The positive solar panel lead is routed to the positive battery terminal by way of a 50
millivolt 50 amp current shunt. From one side of the shunt there is a sense wire run to the
negative input on VM3. From the other side of the shunt there is a sense wire run to the
positive input on VM3.
NOTE:
Consult the Owners Manual or the Manufacturer of the equipment you are measuring
to determine if there is any preference on which power wire the shunt should be hooked up to.
Summary of Contents for RMS-200
Page 1: ...RMS 200 C EtherTek Circuits...
Page 2: ...O w n e r s M a n u a l...
Page 48: ...Block Diagram...
