EtherTek Circuits RMS-200, Owner'S Manual

Page: 10 / 51

R E M O T E M O N I T O R I N G M A D E E A S Y !
RMS-200 is powered up, Now What ?
We recommend configuring RMS-200 before deploying it in the field. Simply plug RMS-
200 into your network or computer using an Ethernet cable (Straight or Cross).
When RMS-200 is turned on it boots the Linux operating system and uses the values
stored in its configuration files to bring up the system. The default values consist of an IP
address, username, and password. The default IP address is 10.10.10.10. The default
username is
root . The default password is pass .
Note: You may at anytime restore the RMS-200 device to
factory default values by pressing and holding down the
micro push button #2 located near the console port and then
turning the RMS-200 device on with the on/off switch.
Release the button when the alarm leds start to flash. When
the alarm leds stop flashing, the RMS-200 unit will be ready
to configure.
Give your computer an ip address in the 10.10.10.X class. For instance use 10.10.10.1.
Set your computers Netmask to 255.255.255.0 There is no need to set a Gateway at this
time. Open your favorite web browser and enter 10.10.10.10 into the address bar, press
enter or the go button. You should be presented with a password box like the one below.
Enter in the default username and password then press the OK button. You will be taken
to the RMS-200 Home page. This page contains an overview of all of the functionality of
the RMS-200 board.
5