Log into your
RMS-200
board with the ftp command. The example below uses the default
RMS-200
ip address 10.10.10.10.
Once logged in, as shown below, type out
bin
and press
Enter
. Next type out
cd /data
and press
Enter
. Then type out
put rootfs-XXX-xxxxxxxxxx
(where XXX is the firmware
build number, and xxxxxxxxxx is the checksum), and press
Enter
. The firmware will be
uploaded to the RMS-200 board. When the upload is complete, type out
quit
and press
Enter
.
Summary of Contents for RMS-200
Page 1: ...RMS 200 C EtherTek Circuits...
Page 2: ...O w n e r s M a n u a l...
Page 48: ...Block Diagram...