409-35011
Rev D
5
of 83
The HV-CP is a semi-automatic, programmable, stand-alone machine designed to strip the cable jacket, braid,
and dielectric foil from round, multi-layer cables (Figure 2) in preparation for the application of crimped
terminals.
Figure 2: Stripping a cable
The machine can process cables with conductor cross-sectional areas ranging from 10mm
2
to 120mm
2
,
(8.8mm to 23mm outside diameter).
The machine and tooling have been designed to allow the processing of many cable types and sizes.
SAFETY
When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.
DANGER
Denotes an imminent hazard that can result in moderate or severe injury.
CAUTION
Denotes a condition that can result in product or equipment damage.
NOTE
Highlights special or important information.
Standards
The HV-CP machine is designed to comply with the following standards:
European Machinery Directive 2006/42/EC
European EMC Directive 2014/30/EU
Ear and eye protection
Always wear approved eye and ear protection while operating equipment.
The following applies to the sound level produced by the HV-CP machine:
The sound pressure levels at the operator position are at the infeed < 69.3 dBA, uncertainty K is 6.3
dBA.
The sound power level is 74.0 dBA, uncertainty K, 7.4 dBA.
NOTE
Operating conditions and procedures during sound testing are in accordance with EN 1218-4:2004 + A2:2009. Sound
pressure level at the operator position have been measured in accordance with EN ISO 11202:2010. The sound power level
has been determined in accordance with EN ISO 3746:2010. Uncertainty has been determined in accordance with EN ISO
4871:2009.