12
Connections and Addressing
Connect AC input power and DMX data cables to the appropriate ports as shown below.
The Paletta connectors are located slightly differently than shown in the illustration below.
However, the descriptions and functions described below are the same.
Connect the incoming DMX data cable to the DMX Input connector. If you are
daisy-chaining the data to other fixtures or DMX-controlled devices, connect the next DMX
cable to the DMX Thru connector. The Selador Series fixtures require that the last fixture
on a DMX line be terminated with a 100
resistor between pins 2 and 3.
Connect the AC Input cable:
Align and insert the power connector. Twist the connector clockwise until it locks into place.
N o t e :
Upon power up, the software version is briefly displayed, then the current DMX address
setting is displayed.
Disconnect the AC Input cable:
Slide back the locking tab, twist the connector counterclockwise and pull to unlock and
disconnect the power connector.
PUSH
Power
DMX Thru
DMX Input
Fuse
Addressing
Power & Data
connections,
fuse locations
Addressing and fans repeat per cell
