ETC Setup and Connect Guide
Paradigm Touchscreen Interface
Paradigm Touchscreen Interface Setup and Connect Guide
Page 8 of 14
ETC
Device Setup Tab
Common settings that are required to set up your Paradigm Touchscreen Interface including the Network
Connection, IP Address, Subnet mask, Gateway, and Volume and Brightness Settings are available on the
“Device Setup” tab.
Network Adaptor and IP Settings
The Network Adapter status on the top of the screen indicates whether a valid Paradigm network is
Online
or
Offline
.
The section for IP Settings provides TCP/IP v4 settings for the Touchscreen Interface.
• Network Connections - always defaults to Net3 Network which is the only network the P-TSI should
be connected.
• Allows for either Automatic or Manual IP settings. Default setting is Manual (IP address:
10.101.18.101, Subnet mask: 255.255.0.0, Gateway: 10.101.1.1).
- Select Automatic when LinkLocal IP (no DHCP) or DHCP.
- Select Manual to manually set the IP address, Subnet mask, and Gateway IP of the Touchscreen.
With Manual selected, touch inside each field to set the numeric values.
Note:
Touch [Save Changes] to save any changes before leaving this tab or the changes will be
lost.
