16
Source 4
WRD
PAR or PARNel
Install a lens
1:
Position the fixture with the front of the unit (lens side) facing you, and
tilted slightly upward.
2:
Hold the lens by the edge and position it so the convex side faces the
rear of the fixture.
3:
From the top of the fixture, slide the
lens behind the lens catchers and
position it behind the tabs on the
bottom of the lens rotator ring. Gently
push the top of the lens inward until it
snaps behind the clip.
PARNel lenses
PARNel lenses come in two versions. The wave/clear lens is in a fixed position
in the rear of the fixture. The wave/stippled lens is in the rotating ring at the
front of the fixture. The wave surfaces face each other.
Change front PARNel lens
Replace lenses if they become cracked or badly scratched.
Note:
Installing the lens with the convex side out will not impair
the optics, but it will make removing the lens difficult.
CAUTION:
Never operate the fixture without a lens in place.
WARNING:
Unplug the fixture and allow it to cool down before
attempting to change a lens.
Spring clip
Retaining clip
WS
Wave/stippled lens
WC
Wave/clear lens
