8
Source 4
WRD
PAR or PARNel
Fixture installation
Install Source 4
WRD
LED
1:
Use oil-free canned air to clean the LED domes prior to installation.
2:
With the fixture resting securely on a flat surface, gently slide the
Source 4
WRD
LED onto the Source 4
WRD
PAR or PARNel Fixture Body
and threaded post while guiding the LED tower into the lamp housing
hole, as shown below. Take care to prevent contact between the LEDs
and the reflector.
3:
Use a #2 Phillips screwdriver to tighten the screw located on the back
end of the Source 4
WRD
LED, directly above the Z-adjustment knob.
4:
Pull gently to verify secure attachment.
5:
Turn the Z-adjustment knob toward PEAK until the knob is loosened.
This sets the LED light source into the appropriate position within the
Source 4
WRD
PAR or PARNel fixture.
WARNING:
RISK OF FIRE OR ELECTRIC SHOCK: Install the Source 4
WRD
LED only onto a Source 4
WRD
PAR or PARNel Fixture Body
or Source Four ellipsoidal fixture body.
CAUTION:
Do not touch LED optic domes. Do not clean LED optic
domes with anything other than oil-free canned air.
Note:
When used as part of a Source 4
WRD
retrofit on a Source
Four ellipsoidal fixture, the Z-adjustment knob adjusts
the field of the LED light for specific applications. On the
Source 4
WRD
PAR or PARNel fixture, however, no
additional adjustments are needed after you loosen the
Z-adjustment knob.
Tighten screw
Z-adjustment knob
Source 4
WRD
PAR or
PARNel Fixture Body
Source 4
WRD
LED
Threaded
post
