ETAS ES600.2, User Manual, Page: 28 / 49

ETAS Commissioning
ES600.2 - User Guide 28
Connecting with the power supply:
1. Connect the cable CBP120 or the cable CBP1205 for the power
supply with the connections 7-29 V of the ES600.2 and with the
desired power supply. In the process, observe the current con
-
sumption of the ES600.2, the data acquisition and interface
modules connected to it and their supply voltage range. The
permissible values are listed in the section “Technical Data” on
page 30 and in the User's Guides of the individual modules.
Starting the application program:
1. Start INCA. The information for the configuration and mea -
sured value acquisition is located in the INCA online help.
6.3.2 Putting a complex module compound in operation
For larger module compounds, it is meaningful to create a drawing of the
planned compound. Figure Fig. 6
- 4 on page 26 shows an example for a module
compound with two cascaded ES600.2 modules and additional ES6xx measur -
ing modules.
To put a complex module compound in operation, the cables CBE100 or
CBE250, CBE130 or CBE140 and CBP120 or CBP1205 are required.
Connecting with the PC:
1. Connect the PC and the FE-HOST connection of the ES600.2
module placed highest in the hierarchy with the cable CBE100.
Connect the RJ-45 plug connector with the open Ethernet
interface of your PC.
or
2. Connect the PC and the GE-HOST connection of the ES600.2
module placed highest in the hierarchy with the cable CBE250.
Connect the RJ-45 plug connector with the open Ethernet
interface of your PC.
Connecting with additional ES600.2 modules:
1. To cascade the ES600.2, connect the FE-HOST connection of
the lower-level ES600.2 with one of the connections ETH1 to
ETH6 of the higher-level ES600.2. Use a cable of type CBE130
or CBE140 for this purpose.
In the hierarchy, the higher-level ES600.2 is located closer to
the host PC.
Connecting with the measuring modules:
1. Connect the HOST connections of your data acquisition and
interface modules from the ES6xx series with one unused con -
nection ETH1 to ETH6 of the ES600.2. Use a cable of type
CBE130 or CBE140 for this purpose. Insert the ends marked in
blue into the HOST connections of the data acquisition and
interface modules and the ends marked in red into the connec
-
tions ETH1 to ETH6 of the ES600.2.