Etac Molift QuickRaiser 205, Technical Manual

Page: 35 / 54

34
Molift QuickRaiser 205 / www.etac.com
Replace rubber profile
Push in emergency stop and discon-
nect battery before any repair or
service.
Remove column from chassis, see page 26
Follow instructions on page 29, and lower control
panel cover to access screw from rubber profile.
Remove screw from rubber profile (T15).
Remove screw and washer (T20)
Pull the rubber profile out from trolley and
column.
Assembly
Use a drill on the top screw on motor 1 to drive
the trolley all the way to the top of the column.
Fasten the rubber profile in the top of the column
with the T15 screw, then drive the trolley 3/5 of
the length towards the bottom of the column.
Thread the rubber profile as shown in the photo
Reassemble screw and washer (T20)
Apply silicone spray for lubrication on the entire
rubber profile before use.
Perform and fill out Safety checklist
after service and repair
Parts
Article no.
2920065 Rubber Profile, L=1156mm
1220339 Pop-rivet