eta DIGI VIENTO 7284, User Manual

Page: 29 / 76

Safety electronics (AUTO STOP)
The safety electronics ensures switching OFF the iron plate heating within 30 seconds,
when the iron is left without any movement in horizontal position or when it is tilted over
to one side, or within 10 minutes, when it is left in vertical position. Function of safety
electronics is signalled by flashing of display
G
and by acoustic signal (beep). The iron is
restarted automatically, when the ironing is resumed.
Storage
After finishing ironing, pour out the unused water from the container (be careful, it can be
hot), or let the rest of the water evaporate and let the iron cool down. Then turn regulator
D to 0 position (steam switched off). Wind power cord M over the back side of cover L and
put the iron to the rest position (Fig. 8) out of reach of children and incapacitated persons.
IV. MAINTENANCE
Before every maintenance, unplug the iron from power supply by taking the fork of
the power cord out of the socket! Do not use rough and aggressive detergents (e.g.
sharp objects, peelers, pot scourers, caustic agents for cleaning or other solvents).
Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown film is created
on the ironing plate (e.g. when ironing starched laundry), you can remove the film by
a detergent containing fine sand. The iron is equipped with a permanent decalcification
system ANTI CA LC that does not require maintenance. But the system cannot fully
prevent creation of calcareous sediments.
V. TROUBLESHOOTING
Problem Cause Solution
Iron is not heated. Power supply not connected Check the cord, plug and the socket
Display shows STAND BY sign Set suitable program with control H
AUTO STOP function activated Move the iron for deactivation of the
safety function
Iron does not
create steam
There is no water in the container Pour water into the container
Steaming regulator is in 0 position Move the regulator into the steaming
position
Low temperature is set for
activating the DRIP-STOP
function
Set a program by the control
H
, during
which you can use steaming and wait
till the iron is heated for using it
Iron does not
create steam
shock
Low temperature is set for
activating DRIP-STOP function
Set a program by the control
H
, during
which you can use steaming and wait
till the iron is heated for using it
The function of steam shock was
used too often during a short
period of time
Let the iron heat and wait for a while
before using the electric shock func -
tion again
Sprinkling
equipment
(additional spray)
does not sprinkle
water
There is no water in the container Pour water into the container
The water system is aerated
Tighten finger on the additional spray
jet hole and at the same time press the
sprinkling device button several times
29
GB
/ 74