17 / 38
–
Do not reel the power cord around the appliance to increase product lifecycle.
–
The power supply cord must not be damaged by sharp or hot subjects, by naked flame
and it must not be immersed into water or bent over sharp edges. Never put it on hot
surfaces and do not let it hang over the edge of a table or a worktop. Hitting, stumbling
over or pulling the power cord, e.g. by children, can result in tilting over or drawing the
appliance down and cause serious injury!
–
If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
–
Use this appliance only for its intended purpose described in these instructions for use!
Never use the appliance for any other purpose.
–
WARNING:
There is a risk of injury in case of incorrect use (not in accordance with the
manual) of the appliance.
– All text in other languages and pictures shown on the packaging, or the product itself, are
translated and explained at the end of this language mutation.
–
The producer does not undertake any responsibility for damage or injuries caused by
improper use of the appliance and the accessories (e.g.
food deterioration, injuries,
fire
) and its guarantee does not cover the appliance in the case of failure to comply with
the safety warnings above.
II. FEATURES OF THE DEVICE
(pic. 1)
A – propulsion unit
A1 – switch/speed selector
A3 – closures
A2 – propulsion shaft
A4 – supply cord
B – container with a drain
B1 – safety lock
C – sieve
D – lid
D1 – feeding opening
E – stamper
F – pulp collector
G – juice container
G1 – lid with foam separator
H – cleaning brush
III. PREPARATION AND USE
Remove all packaging material and remove the appliance with accessories. Remove all
adhesive foils, stickers or paper from the appliance. Wash all parts which will come in
touch with food in hot water with soap, rinse them thoroughly with clean water and wipe dry
or let dry before first use.
Assembly
(pic. 1)
Insert the pulp container
F
into the holder.
Slide the container
B
into the propulsion unit
A
all the way.
Put the sieve
C
onto the propulsion shaft
A2
a secure it with slight pressure.
Put the lid
D
onto the container
B
and secure it by snapping the closures
A3
(slide the
upper parts of the closures onto the protrusions in the grooves of the lid first and then snap
in their bottom parts).
Proceed reversely when removing the individual parts.
Note
: If the has been placed and secured incorrectly, the appliance will not turn on.
GB
Summary of Contents for 0032
