12
13
CLEANING
After each use, to avoid spotting and bad smells clean the appliance by following these steps:
• switch it off and unplug from the mains
• remove the upper part A
• empty out the container
by following the diagram
shown in STEP 4 of «STARTING THE DIFFUSER» to avoid any contact
with electrical parts
• clean the water container in order to remove all residues, for it use absorbent paper impregnated with a mild detergent (soap,
washing-up liquid… Do not use aerosol sprays, solvents or abrasive products that might damage the appliance).
Then wipe it with a dry cloth:
• use a wet cotton bud (water only) to clean the ceramic disk
• as this disk is very fragile and sensitive, make sure not to press too strong and clean it after each use for longer operating life.
Be careful not to spill water on the bamboo part of the diffuser. If you happen to do so, wipe it off immediately.
NEW USE
• see STAGE 1 of the section «STARTING THE DIFFUSER»
• replace the water in the container frequently to avoid any residue that might damage the appliance
• empty out the liquid remaining after each use and clean the water container and its ceramic disk each time you change the water
or fragrance, for an optimum fragrance.
LONG PERIOD WITHOUT USE
If the appliance is not going to be used during a long period, clean it, dry it (by following the instructions in section «CLEANING»),
and keep it in a dry place.
OPERATION AND MAINTENANCE INSTRUCTIONS
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
Causes
Solutions
No mist when the appliance is
switched on
The appliance is not plugged in
Make sure that the power adapter is properly
connected to the appliance and fully plugged in
to the wall socket
Water level too low
Fill the water container
Water level
exceeds 100 ml
Empty out excess water
The end of part A is obstructed
Make sure that nothing is preventing the release
of the mist
Mist stops while the diffuser is
in operation
Water level too low
Fill the water container
Accumulation of water drops in the part A
Switch off the diffuser, remove part A then clean
off the accumulated water drops
Accumulation of water drops on the air outflow 3
Switch off the diffuser, remove part A then clean
off the accumulated water drops
Insufficient mist
The ceramic disk is dirty
Clean the ceramic disk as described in the
«CLEANING» instructions
An excess of Estéban refresher oils or essential
oils has been poured into the container
Empty the appliance and clean it
Accumulation of water drops in the part A
Switch off the diffuser, remove part A then clean
off the accumulated water drops
The light does not switch on
Diffuser failure
Bring the diffuser back to the retailer within the
after-sales service support legal deadline
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
GB
GB
