RII113-A-201222.docx
Page 13 of 15
5.2.1.
Illuminated Spy Proof Housing, if equipped;
5.2.1.1.
Mark the mounting holes on wall surface, at the suggested mounting height,
using the 0.200” [5.1mm] hole mounting points. Also mark the suggested cut
out opening. This may be a 1” diameter hole, top center, for the connecting
harness.
5.2.1.2.
Outline a cable clearance hole, as shown in figure 5 above, & cut a large enough
hole to clear cable connectors & splices to the control panel.
5.2.1.3.
If equipped with the optional SH-34W illuminated shroud, connect the two-wire
harness from the reader, terminated in a two-prong Molex style connector to the
illumination light bar harness. These are keyed to fit in only one way.
5.2.1.4.
If the reader is being supplied only 5V for its’ operation, the jumper on the
illumination light bar should be removed, or cut.
5.2.1.5.
Do not use the threaded inserts for mounting hardware as these are used to
mount the reader to the housing.
5.2.1.6.
Use anchor bolts or screws to mount the housing onto the wall or gooseneck.
5.2.2.
Reader Housing
5.2.2.1.
If the spy proof housing is not required, the reader may be mounted directly to
the wall or j-box using mounting hardware supplied with the reader. There are
also mounting hardware to mount the keypad to the reader, use only hardware
from the reader kit,
do not use the keypad supplied hardware
.
5.2.2.2.
Temporarily connect the keypad to the reader. [Do not install the voltage jumper,
the keypad will operate on +12V normally].
5.2.2.3.
Configure the keypad, as desired, as outlined in paragraph 4 above.
5.2.2.4.
The reader may now be mounted, optionally, to the shroud, using supplied
hardware, or directly to the J-Box, by screwing the reader housing into threaded
inserts, on the shroud, or alternately directly into the J-Box or wall, using #6-32
screws.
5.2.2.5.
The keypad may then be mounted to the reader housing, using supplied
hardware, screw the keypad onto the reader housing. Install the label overlays
onto the keypad & reader.
