Page 9
G500-G525-I02-070214
Low Setting
If the pilot is not already lit, light the pilot as instructed.
With control knob at
PILOT
setting, depress and turn anti-clockwise to
LOW
setting
and release the knob.
High Setting
If the stove is not already lit on
LOW
setting, ignite stove to
LOW
setting as instructed.
Turn the control knob anti-clockwise until the
HIGH
setting is reached. Check that the
supply pressure and/or setting pressure are in accordance with that given in the
TECHNICAL INFORMATION section.
Turning the Stove OFF
From any heat setting, depress control knob fully and turn clockwise to
PILOT
position.
Disconnect the pressure gauge, replace the test point sealing screw and test for gas
soundness.
Turning the Pilot OFF
From any heat setting or the
PILOT
position, depress control knob fully and turn
clockwise to
OFF
position.
Fig 7 – G500/G525 Contemporary C series control knob.
CHECK FOR SPILLAGE
Close all doors and windows in the room containing the appliance. Light the stove and
turn the control knob to ‘HIGH’, leave the appliance for 5 minutes.
Apply a smoke match along the bottom edge of the draught diverter. The installation is
satisfactory if the smoke is drawn into the stove. If in doubt wait a further 10 minutes
and then repeat the test.
