Espina XTP115, Instruction Manual

Page: 101 / 116

23
Fig. 35
Using the chainsaw without the upper tube
If the lower tube by itself is long enough for your work, you can use the chainsaw without the upper tube. First
remove the upper tube/coupler-assembly from the gearcase according to instructions in chapter ”Disassem-
bling the tubes”, then assemble the gearcase onto the lower tube-assembly according to instructions in chap-
ter ”Assembling the tubes”. Fig. 35
Installing the guide bar and chain
WARNING! Never attempt to install, replace or adjust the chain while the engine is running.
WARNING! The chain is very sharp. Always wear safety gloves when handling the chain.
OBSERVERA! When you need to change or replace chain loops, let them soak in oil overnight before installa-
tion. This will prolong their operating life.
1. Using a plug wrench, open the sprocket cover nuts by turning counterclockwise and remove the sprocket
cover. Fig. 36
IMPORTANT! Failure to align the guide bar and chain tensioning pin can cause serious damage to the
sprocket cover, guide bar, chain tensioning pin or the whole cutting head-assembly.
2. Place the guide bar over the guide bar adjustment studs on the cutting head-assembly and align the chain
tensioning pin with the hole in the guide bar. Fig. 37
3. Install the chain loops over the drive links within the guide bar groove, then align the chain over the drive
sprocket. Make sure the cutters are properly oriented as shown in figure 38. If chain installation is difficult
or if the chain appears too tight, refer to chapter ”Adjusting the chain”.
WARNING! Never operate the chainsaw without the sprocket cover in place.
4. Install the sprocket cover over the bar studs and tighten the nuts using finger-pressure only.
5. Adjust the chain tension according to instructions in chapter ”Adjusting the chain”.
Press
latch
Latch
Latch protector
Locking hole
Upper
tube
Coupler
screw
Coupler
Powerhead/
lower tube
Latch
protector
Coupler
screw
Coupler
Fig. 32 Fig. 33 Fig. 34
Guide bar and chain
Handle
Lower tube
Throttle trigger
Hanger
Strap
Ignition switch