10
OPERATION
VICTORY-LX 3 LEG ELECTRIC TABLE BASE
CHANGING THE HEIGHT DISPLAY UNITS
This function allows you to change the display units from
centimeters to inches or the other way around.
• Press and hold
S
, then press and hold the DOWN button.
Continue to press both buttons for about 3 seconds.
— The height information will change between centimeters
and inches.
• Release both buttons.
RESET THE CONTROL UNIT TO FACTORY SETTINGS
To reset the control unit to factory settings, re-initialize the table.
• Press and hold the UP and DOWN buttons simultaneously
for more than 3 seconds.
— The legs will begin to move down at half speed of normal
operation.
• Continue to press the UP and DOWN buttons.
— The legs will move down to the lowest position, then
rebound
1
/
16
" to
3
/
16
" (2mm to 5mm) and stop.
• Release the UP and DOWN buttons at the same time. This
completes the initialization procedure.
If one or more motors are changed
in a system, the control unit must be
reset to factory settings.
ADUSTING THE DIGITAL KEYPAD READOUT
This function allows you to change the readout of the digital display.
• Verify the display unit format (inches or mm), set the table to any height, measure the actual height, and
write down the number (inches or mm).
• Press and hold the
S
button. Then press and hold the button for about 3 seconds until the first number on
the digital display flashes.
• Release the buttons then press or to change the first number you measured.
• Press the
S
button agin. The 2nd number on the digital display flashes.
• Press or to change the 2nd number you measured.
• Press the
S
button again. The 3rd number on the digital display flashes.
• Press or to change the 3rd number you measured.
• Press the
S
button to complete the operation.
