ESD QUICK 713, Instruction Manual

Page: 11 / 26

10
5. Click “TOOL3” key into the single displaying window of the SMD rework tool. The LCD displays “SET”
and current setting temperature. Click “TEMP
▲
” or “TEMP
▼
” to set the temperature of the SMD rework
tool. Click “AIR
▲
” or “AIR
▼
” to set the airflow of the SMD rework tool. When the SMD rework tool is in
the sleeping state, the window shows “---”.
6. In the single displaying state, it can turn on or turn off the corresponding tool by clicking the corresponding
“TOOL” key. When the window displays “-”, which means the tool has been turn off.
6.2 Operation of the Soldering Iron
6.2.1 Enter into or Exit from the Soldering Iron
1. Turn on the power switch, click“TOOL1” key into the single displaying state of soldering iron.
2. If displaying “-” at the soldering iron window, which means the soldering iron is in the shutting state and
cannot be operated. At the state, if pressing “TOOL1” key about three seconds, the soldering iron window
will shows “ON”, which means the soldering iron can work normally.
3.
Pressing “TOOL1” key again, the soldering iron window will shows “OFF” and then “-”, which means the
soldering iron has been into the shutting state.
4. If displaying “---” at the soldering iron window, which means it is in the sleeping state. The soldering iron
comes to heat up when waking up from the sleeping state, the “ ” lights and when the temperature is stable,
the “ ” flickers.
6.2.2 Set the Temperature of the Soldering Iron
Make sure the temperature of the station can be adjusted (the password is right or the password is initial “000”).
Click “TOOL1” key into the single displaying window of the soldering iron, and then click “TEMP
▲
” or “TEMP
▲
” key to change the temperature (refer to the temperature setting).
6.2.3 Select a Correct Tip
1. Select a tip which maximizes contacting area between the tip and solder joint. Maximizing contact area
transfers the heat more efficient, helping the operators to produce high quality solder joints quickly.
2. Select a tip with transferring the heat to the solder joint well. A tip with shorter length can control more
precise. And the Longer or angled tip may be needed for soldering densely populated boards.
In temperature setting state In airflow setting state