Overview
CAN-Control-I/O Software Rev. 1.1
1 - 5
User parameter
Comment
Default setting
[HEX]
first Tx_activate_delay
$03E8
(1000 ms)
module transmits at the earliest 1 s
after power-on or RESET on the bus
outerr/vccmask
$FFFF
transmission of status message in
case of rising and falling edge of a
status bit
error_hold_time
$0010
(16 ms)
error hold time
input_change_mask_63-48
$FFFF
transmission of all input states, if at
least one input changes it’s state
input_change_mask_47-32
$FFFF
input_change_mask_31-16
$FFFF
input_change_mask_15-0
$FFFF
vccdef_7
$8B53
switching level of the supply voltage
monitor for each supply voltage is
default
V
= 17,8 V and
MIN
V
= 29,8 V
MAX
vccdef_6
$8B53
vccdef_5
$8B53
vccdef_4
$8B53
vccdef_3
$8B53
vccdef_2
$8B53
vccdef_1
$8B53
vccdef_0
$8B53
Table 1.2.3:
Default settings of the user parameters of the module
The user parameters will be explained in detail in a special chapter.
Summary of Contents for C.2071.01
