Wiring
Installation and technical data
CAN-PCI/360
Rev. 1.3
25
ll
< 0,3 m
CAN_L
CAN_GND
CAN_H
PE
ll
< 0,3 m
CAN
Board
CAN
Module
CDIO16/16
Net 2
Net 1
Female Connector
Male Connector
CAN
Module
CMIO
CAN
Module
CAI810
CAN-SPS
Interface
CSC595/2
or
CAN-PC Board
CAN
Module
CDMS4
T-Connector
Terminator
Male Terminator
Connecting
CAN_GND to
Protective Conductor PE
Terminator
with PE Connector
T-Connector
Female Terminator
e.g. PCI/331,
ISA/331,
VME-CAN2, etc.
Cabling
•
for devices which have only one CAN connector use T-connector and dead-end feeder (shorter than
0.3 m) (available as accessory)
Figure:
Example for correct wiring (when using single shielded wires)
Terminal Resistance
•
use
external
terminator, because this CAN later be found again more easily!
•
9-pin DSUB terminator with male and female contacts and earth terminal are available as
accessories
Earthing
•
CAN_GND has to be conducted in the CAN wire, because the individual esd modules are
electrically insulated from each other!
•
CAN_GND has to be connected to the earth potential (PE) at
exactly one
point in the net!
•
each CAN user without electrically insulated interface works as an earthing, therefore: do not
connect more than one user without potential separation!
•
Earthing CAN e.g. be made at a connector
