ESD electronic CAN-CBM-PLC/331-1, Hardware Manual

Page: 69 / 149

i
Overview
CAN-CBM-SIO, CAN-CBM-SIO4 Software Rev. 1.0 1 - 5
Default values of user parameters (regardless of protocol used)
First Tx-activate delay 10.000 msec
CAN-Tx mode $1411, i.e. 'MinChar', 'MaxChar' = 1,
(all channels) 'Inhibit-Time' = 20 ms
Serial mode
(all channels)
$2273, ie. CTS* active (terminal interface: no CTS),
9600 baud,
2 stop bit (terminal interface: 1 stop bit)
no parity,
8 bit/character
Table 1.2.3:
Default settings of parameters of the module
Explanations of the terms for the user parameters in table 1.2.3:
First Tx-activate delay... Delay after a RESET before the module starts transmitting messages to
the CAN or the serial interfaces.
CAN-Tx mode... 'MinChar' and 'MaxChar' determine the minimum and maximum
number of data bytes which are to be transmitted within the CAN frame
on the CAN-bus. ‘Inhibit time’ shows the delay of the CAN controller
between the last successful transmission on the CAN-bus and the start
of the following transmissions.
Serial mode... By means of serial mode the serial interfaces are set.