ESD electronic CAN-CBM-PLC/331-1, Hardware Manual

Page: 99 / 149

Overview
esd Protocol for CAN Modules Rev. 3.2 1 - 6
0
0
8
8
HIGH
LOW
SERIAL
LED 2
LED 1
Coding Switch SW211 (High)
Coding Switch SW210 (Low)
1.6 Advanced Configuration
With the
Advanced Configuration
you can set up to 15 additional parameters with the coding switches.
To set the value of the parameters you have to execute the below described step-by-step instruction.
Fig. 1.6.1:
Names of LEDs and coding switches
1.6.1 Setting Instruction
Step
State of LEDs
Action/Setting of Coding Switches
LED 1 LED 2
1 OFF OFF
- set both coding switches to ‘F’
- switch on the power supply of the module
2 flashes fast flashes slow
- now you have 10 seconds to set the switch HIGH to the
parameter number and the switch LOW to the parameter value
(parameters see table below)
Only, if previous step was step 4:
- if do not want to change more parameters, set both coding
switches to ‘F’ to write the changed parameter(s) to the
EEPROM
3
lights
continuously
flashes slow
- the local firmware verifies your settings of step 2 in 2 seconds
4 flashes fast
lights
continuously
- if this light state appears, the changed parameter value is
accepted
- after 2 seconds the firmware continues with step 2, except you
have set both coding switches to ‘F’, than the firmware
continuous with step 5
5 flashes fast flashes fast
- the LEDs are flashing for approx. 10 seconds, then the module
is automatically reset; within this time you have to set the
module no. at the coding switches
- after the reset the module starts with the changed parameters
and the set module no.