ESD electronic CAN-CBM-PLC/331-1, Hardware Manual

Page: 104 / 149

Overview
esd Protocol for CAN Modules Rev. 3.2 1 - 11
The parameter interchange can lead to the setting of parameters, to the reply of already adjusted
parameters or to the execution of a command. At the command interchange and the setting of
parameters the highest bit of the command byte is always '1', at the request of parameters it is always
'0'.
The requested reply of the module is only sent once by the module. The identifier (CTxId) which had
been allocated to the module for this transmission is not stored on the module. If another transmission
is desired an INIT Id with the corresponding parameters has to be transmitted to the module again.
If the module processes faultlessly and the CAN is free, it transmits the reply within 200
:
s (max.
10 ms).
Normally, at the reply of the actual parameter condition of the modules, in the first byte the contents of
the received command byte and in the second byte the contents of the sub command byte is given.
This is not the case if the second byte is used for the display of other parameters or an unknown
command or sub command byte had been sent to the module. In the second case a message containing
only one byte with the contents $FF is given back to the CAN.
The given value ranges of the parameters have to be kept, because otherwise the faultless execution
of commands is not guaranteed! No error message occurs after wrong entry of the parameter
values.
Below the parameters and commands will be specified. The examples added subsequently to the
specification should clarify the function course further.
The description of the bytes of the INIT Id restricts to those which are relevant for the corresponding
mode.
Byte 3 (sub command 2) should, if it is not needed, always be recorded with $00. In byte 4 the actual
module no. has to be entered, as already mentioned above.