15
Low Temperature BOD Incubator
4.4 Removal of deposits
Deposits can be removed by three ways, depending on the composition of loads and contacted materials.
Automatic high temperature decontamination
Note:
Take out all combustible materials and set overheat protector to maximum value beforehand.
Spray standard acid-free disinfectant
Note:
Before startup, thoroughly wipe the unit with dry cloth as explosive gases may be generated during pollutant
removal.
Indoor parts can be decontaminated by high-pressure decontamination.
Note:
Safety measures need to be implemented to ensure the safety during deposits removal.
4.5 UV Lamp Replacement
If the UV lamp in inner chamber is damaged, user can replace it by following below steps:
1.
Open outer door and glass door.
2.
Unscrew the cover.
3.
Slide the UV lamp caps (1) to aside therefore the UV lamp can be removed.
NOTE:
Ensure the equipment is turned OFF and power supply is disconnected during UV lamp replacement.
Pay attention as the UV lamp may drop as the caps are slide aside
UV light is harmful to health. Don’t open outer door when the UV lamp is ON.
Don’t put big loads or many loads into inner chamber that may destroy UV lamp.
4.6 Maintenance/Service Log
It is good practice (and in some cases regulatory requirement) to maintain a log of all maintenance work
carried out on your freezer.
Cap
Cover
Washer
Screw
Summary of Contents for Isotherm IFC-110-8
