REV0709
Parts List and Operating Instructions
3. With spade tip down and cylinder in retracted position, insert
spade and cylinder assembly between open sides of frame.
Place spade tip between tire bead and rim flange. See Figure 3.
Figure 3
4. Lift cylinder until trunion engages frame shoulder and move stop
screw into support cylinder. See Figure 4.
Figure 4
5. Apply pressure to cylinder and spade by means of pump until spade
has moved tire bead toward center of rim assembly far enough to
permit the placing of a bead wedge between bead and flange on
each side of the tool. Do not stand in front of tool is under pressure.
See Figure 5.
Figure 5
6. Release pump pressure. Remove spade and cylinder
assembly from frame. Loosen clamping jaw bolts and remove
from flange. Move to spot approximately 90° from first
application (either direction) and repeat entire procedure.
Repeat procedure until tire bead is free. Four or five
applications usually accomplishes this. See Figure 6.
Figure 6
