Figure 2
2.
Attach Cross Tube (
#7
) to Caster Beam Assemblies (
#8
) using four Thumb Screws (
#28
) as shown
in
FIGURE 2.
Tighten bolts snug but
DO NOT
over tighten.
READ AND FOLLOW ALL ASSEMBLY, OPERATING,
fAND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST
TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE
TOGETHER!
Parts Needed:
1 pc -
#7
Cross Tube
Hardware Needed:
4 pcs -
#28
#10-24 Thumb Screw
1.
Slide a Caster Wheel
with
Lock (
#30
) into Caster Beam
as shown in
FIGURE 1
. On the other end of the Caster
Beam attach a Caster Wheel
without
Lock (
#9
).
Make sure you have one Caster Wheel with lock and a
Caster Wheel without lock for each Caster Beam.
Repeat this step to attach the Casters to the second
Caster Beam.
9
9
9
8
8
Parts Needed:
2 pcs -
#8
Caster Beam
2 pcs -
#9
Caster without lock
2 pcs -
#30
Caster with lock
Rubber Hammer
Figure 1
4
7
30
with lock
30
without lock
with lock
without
lock
8
30
NOTE:
Make sure the Caster
Stem is completely installed
into Caster Beam as shown.
28
NOTE: If casters came pre-assembled
on Caster Beam (#8), skip to Step 2.
NOTE: Assemble with
threaded insert facing down.
8
Summary of Contents for STIGA T8561
Page 10: ......
