7.
Attach U-Support (
#3
) and Strut Tubes (
#4
) using two Screws (
#15
) as shown in
FIGURE 7
.
8.
Attach Long Hinge & Mounting Bracket Assemblies (
#5
) to Strut Tubes (
#4
) using two Bolts (
#12
), two Spacers (
#11
),
two Flat Plastic Washers (
#13
) and two LockNuts (
#14
) as shown in
FIGURE 7
and
DETAIL F
.
Tighten Nuts snug, but
DO NOT
OVERTIGHTEN
, hinges must pivot.
9.
Attach two Corner Protectors (
#25
) to Top Assembly using four Screws (
#15
) with four Washers (
#26
) as shown in
FIGURE 7
.
Repeat for other Table Top.
Figure 7
14
12
11
13
15
Hardware Needed:
2 pcs -
#11
Spacer
2 pcs -
#12
Phillips Rd. Hd. Bolt
2 pcs -
#13
Flat Plastic Washer
2 pcs -
#14
LockNut
6 pcs -
#15
Phillips Rd. Hd. Screw
4 pcs -
#26
Washer
Part Needed:
2 pcs -
#25
Corner Protector
15
26
25
3
4
5
9
CORRECT POSITION OF HINGE
In the correct position Hinge (
#5
) will look
like a “
V
” when attached to Strut Tube (
#4
).
CAUTION:
Position hinges exactly as
shown in
DETAIL F
or table will not
operate correctly and could be damaged.
DETAIL F
14
12
11
13
5
4
NOTE: Tighten screws snug,
but do not overtighten, causing
screws to strip in metal tube.
ATTENTION:
If hinge is positioned as shown
below (
DETAIL E
), rotate the hinge as shown in
DETAIL F
. Do not take hinge off.
INCORRECT POSITION OF HINGE
4
5
DETAIL E
DO NOT OPEN THE TABLE TO PLAYING POSITION
UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE
TABLE STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS BODILY INJURY
OR PROPERTY DAMAGE.
Note: If hinge (#5) is positioned as shown in DETAIL E, you will have to rotate the hinge to the position shown in
Detail F. DO NOT unscrew the hinge, you can rotate the hinge without unscrewing it from the table. If you want to
see a video on how to position Hinge (#5) go to:
ht
tp://www.escaladesports.com/customer-service/videos.html
Summary of Contents for STIGA T8561
Page 10: ......
