-- 22 --
bm38d1ea
6.4
Replacing and inserting wire
S
Open the side panel.
S
Disconnect the pressure sensor by folding it backwards, the pressure arm is
folded up.
S
Straighten out 10--20 cm of the new wire. File away burrs and sharp edges from
the end of the wire before inserting it into the wire feed unit.
S
Make sure that the wire goes properly into the feed roller’s track and into the
outflow nozzle or wire guide.
S
Fold down the pressure arm and secure it to the pressure sensor.
S
Close the side pannel.
6.5
Changing feed roller OrigoFeed 30--2
S
Open the side panel.
S
Disconnect the pressure sensor (1) by folding it
backwards.
S
Disconnect and remove the Allen screw (2) and the
washer.
S
Pull out the feed roller (3).
During installation, repeat the above in the reverse
order.
Choice of track in the feed roller
Turn the feed roller with the dimensioning mark for the
required track towards you.
6.6
Changing feed roller OrigoFeed 30--4
S
Open the side panel.
S
Disconnect the pressure sensor (1) by folding it
backwards.
S
Disconnect the feed rollers (2) by unscrewing the
nuts (3) and pulling out the rollers.
During installation, repeat the above in the reverse
order.
Choice of track in the feed roller
Turn the feed roller with the dimensioning mark for the
required track towards you.
GB