ESAB EPP-200, Instruction Manual

Page: 15 / 52

15
NOTICE
3.4.1 Primary Power Speci fi cations
EPP-200 is a 3-phase unit. Input power must be provided from a line
(wall) disconnect switch that contains fuses or circuit breakers in
accordance to local or state regulations.
Recommended input conductor and line fuse sizes:
Dedicated power line may be necessary.
EPP-200 is equipped with line voltage compensation but to avoid
impaired performance due to an overloaded circuit, a dedicated
power line may be required.
4J[FTQFS/BUJPOBM&MFDUSJDBM$PEFGPSB¡$ ¡'SBUFEDPQQFS
DPOEVDUPST!¡$ ¡'BNCJFOU/PUNPSFUIBOGPVSDPOEVDUPST
in raceway or cable. Local codes should be followed if they specify sizes
other than those listed above. Input current values given in this table
are at maximum output power (32kW) 200 amps at 160VDC.
Rated Load Input and Ground
conductor*
CU/AWG
Time delay
'VTFTJ[F
(amperes)
Volts Amperes
200/208 115 1 150
230 100 2 125
380 60 4 80
415 55 6 70
460 50 6 70
575 40 8 60
SECTION 3 INSTALLATION