15
Cable Tie
Hose Clamp
SET-UP ASSEMBLY
Wire Harness Installation
NOTE:
If the loader is equipped with an attachment
control package, the appropriate harness should be
installed from the factory.
If the attachment was ordered with the pistol grip
control harness, follow these instructions:
1. Install the control handle on either steering lever,
whichever you prefer, with hose clamps.
NOTE:
The control handle bracket can be
positioned several different ways. We
recommend it be positioned as shown.
2. Put a cable tie around the wiring harness and the
steering lever.
3. Install the wiring harness receptacle bracket on
either the loader arm or near the hydraulic quick
couplers.
NOTE:
It may be necessary to make an adapter
bracket in order to attach the wire harness to the
loader.
4. Route the wiring harness back along the tube
lines on the loader arms and fasten with cable
ties.
5. Open the rear door. Pull the excess wiring
harness into the engine compartment.
6.
Raise the operator cab. (See loader’s operator’s
manual for the correct procedure.)
