Instalacion_10 v1.2.fm
- 10/1
2
/07
INSTALLATION
64
Installation manual
Mount the actuator on the front support
Mount the actuator on the rear support
Mount the cover and the top.
1
Introduce the actuator swivel joint (1) in the front
support pin (2).
2
Secure the swivel joint using the safety washer (3).
3
Only models with absorption: adjust the swivel joint
in order to achieve the required absorption distance.
)
The absorption distance reduces as the swivel
joint is unthreaded. The absorption distance
increases as the swivel joint is threaded.
1
Introduce the fork (1) in the support (2).
2
Position the vertical pin (3), crossing the orifices of
the fork and of the support.
)
Vertical pin:
ø
= 12mm, L = 37mm
3
Secure the pin using the safety washers (4).
4
Position the caps (5) to close the housing.
1
Introduce the rods (4) through the orifices of the top
(1) and the internal cover guides (2).
2
Thread the rods in the front top of the actuator (3)
and tighten family.
3
Position the caps (5) in the holes in the top
