Pogramacion_v.
01.fm -
6/4/11
START UP AND PROGRAMMING
56
Installation Manual
Radio Code Recording (only with RSD) and Gate Travel (D1= “
P
”)
O
Before recording the gate travel, ensure the
rotation direction of the actuator is correct (see
“Prior Conditions Programming (D1= “
C
”)” on
page 55).
The recording of the radio code described below is
only valid if the plug-in receiver RSD is installed. If
another receiver is used, record the radio code as
described in the corresponding instructions.
1
Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2
Press the buttons ^ and
V
until D1 shows the letter
P
flashing. Press ENTER to confirm. D2 flashes.
3
Press the buttons ^ and
V
until the required D2
parameter appears (see chart). Press ENTER to
confirm. D3 and D4 flash.
4.a
Radio code recording
(D2=
1
or D2=
2
):
• Press the emitter button. If the code is correctly
recorded, D3-D4 stop flashing (remain static).
4.b
Gate travel recording
(D2=
3
):
• Press ENTER. D3-D4 stop flashing (remain static)
• Press the total opening button. D3-D4 flash
again whilst the recording of the operations is
made automatically. The gate carries out the
following movements:
–
Reset (close position search)
–
Total opening
–
Total close
• When recording is finished, D3-D4 stop flashing
(remaining static).
5
Press ESC to return to the previous display.
Main Functions Programming (D1= “
F
”)
1
Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2
Press the buttons ^ and
V
until D1 shows the letter
F
flashing. Press ENTER to confirm. D2 flashes.
3
Press the buttons ^ and
V
until the required D2
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
4
Press the buttons ^ and
V
until the required D3 and
D4 value appears (see chart). Press ENTER to
confirm.
5
Press ESC to return to the previous display.
For operation different to the options defined in this
menu, access the advanced functions menu (see
“Advanced Functions Programming (D1= “
A
”)” on
page 57).
D1
D2
D3
D4
P
1
o
ç
Total opening radio code
recording
2
o
ç
Pedestrian opening radio
code recording
3
o
ç
Gate travel recording
D1
D2
Parameter
D3
D4
P r e -
d e t e r m i n e d
option
Options or values
F
1
Operation mode
a
0
1
Automatic
0
2
x
Semi-automatic
2
Standby in automatic mode
1
5
x
15 seconds
0...5. 0...9
59
= 59 sec;
2.5
= 2 min. 50 sec, etc
3
Pedestrian opening
0
0
x
Pedestrian opening is not carried out
1
0
10% of total opening
2
0
20% of total opening
3
0
30% of total opening
4
0
40% of total opening
5
0
50% of total opening
a. For further details, see “Operation modes” on page 46.
Pogramacion_v.01.fm Page 56 Wednesday, April 6, 2011 3:19 PM
