Erreka Dolfin DOS424E, Installer Manual

Page: 65 / 114

Pogra
m
ac
ion
_153.fm -
5/9
/11
START UP AND PROGRAMMING
DOLFIN operator for sliding gates
61
Radio code programming (only with RSD) and gate open/close programming (D1= “
P
”)
O
Before programming the gate open/close,
ensure the turning direction of the operator is
correct (see “Initial Conditions Programming
(D1= “C”)” on page 60).

The radio code programming described below is
only valid if the RSD plug-in receiver has been
installed. If a different receiver is used, programme
the radio code as described in the corresponding
instructions.
1
Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2
Press the buttons ^ and
V
until D1 shows the letter
P flashing. Press ENTER to confirm. D2 flashes.
3
Press the buttons ^ and
V
until the required D2
parameter appears (see chart). Press ENTER to
confirm. D3 and D4 flash.
4.a Radio code programming
(D2= 1 or D2= 2 ):
• Press the transmitter button. If the code is
correctly programmed, D3-D4 stop flashing
(remain static).
4.b Gate open/close programming
(D2=
3
):
• Press ENTER. D3-D4 stop flashing (remaining
static)
• Press the total opening button. D3-D4 flash
again whilst the programming of the operations
is done automatically. The gate carries out the
following movements:
–
Reset (close position search)
–
Total opening
–
Total close
• When programming is finished, D3-D4 stop
flashing (remaining static).
5
Press ESC to return to the previous display.
Main Functions Programming (D1= “
F
”)
1
Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2
Press the buttons ^ and
V
until D1 shows the letter
F
flashing. Press ENTER to confirm. D2 flashes.
3
Press the buttons ^ and
V
until the required D2
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
4
Press the buttons ^ and
V
until the required D3 and
D4 value appears (see chart). Press ENTER to
confirm.
5
Press ESC to return to the previous display.

For operation different to the options defined in this
menu, access the advanced functions menu (see
“Advanced Functions Programming (D1= “A”)” on
page 62).
D1 D2 D3 D4
P 1 o ç
Total opening radio code
programming
2 o ç
Pedestrian opening radio
code programming
3 o ç
Gate open/close
programming
D1 D2 Parameter D3 D4
D e f a u l t
option
Options or values
F 1
Functioning mode
a 0 1 Automatic
0 2 x Step-by-step
2 Standby in automatic mode 1 5 x 15 seconds
0...5. 0...9 59
= 59 sec;
2.5
= 2 min. 50 sec., etc
3 Pedestrian opening 0 0 x Pedestrian opening is not carried out
1 0 10% of total opening
2 0 20% of total opening
3 0 30% of total opening
4 0 40% of total opening
5 0 50% of total opening
a. For further details, see “Functioning modes” on page 50.