12
Replacement installation
NOTE:
Turn off the
engine prior to
replacing the Ehubo2
Unpack the
replacement Ehubo2
and also place it screen
down on a clean, flat surface.
Make sure to not scratch or damage the screen!
EXISTING EHUBO2:
Push down the cable plug latch
to release the cable plug
(J)
and
carefully slide the cable plug off the
internal connector
(K)
.
REPLACEMENT EHUBO2:
Carefully insert the cable plug
(J)
to the internal connector
(K)
.
Make sure the cable plug latch clicks
into place to safely secure the plug.
Lift the rear hatch
(H)
off the
existing Ehubo2
and slide it off the
cable grommet
(I)
. Lift the rear hatch
off the
replacement Ehubo2
.
Remove the
existing Ehubo2
from its mount and carefully
place it screen down on a clean, flat surface.
Make sure to not scratch or damage the screen!
1
2
3
5
4
6
RAM
I
J
K
To replace an existing Ehubo2,
- disconnect the power cable from the existing Ehubo2 and
- connect it to the replacement Ehubo2.
Follow these simple steps:
H
F
J
K
G
Remove the rear hatch security
plugs
(F)
of both,
the
existing
and
the
replacement Ehubo2
. This is easily
done by inserting a flathead screwdriver
and scooping out the plug. Unwind the
screw underneath
(G)
.