Getting Started with the Configuration Manager
EN/LZT 108 6492 R1
19 (98)
April 2003
Field
Description
Operation Mode
Select Enabled.
If set to Disabled, the device cannot provide Internet connectivity for your
network.
Encapsulation
Select the connection type your ISP uses to communicate with your
HM210dp/di.
VPI and VCI
Enter the VPI/VCI values given by your ISP.
Bridge
This setting enables or disables bridging between the HM210dp/di and your
ISP. Your ISP may also refer to this using "RFC 1483" or "Ethernet over
ATM".
IGMP
This setting enables or disables the Internet Group Management Protocol.
Contact your ISP whether to enable this setting.
IP Address and Subnet
Mask
If your ISP has assigned a public IP address to your LAN, enter the IP
address and the associated subnet mask in the boxes provided.
Otherwise keep the default 0.0.0.0/0.0.0.0.
Use DHCP
Default Route
When enabled, the IP address specified above will be used as the default
route for your LAN.
Gateway IP Address
Specify the IP address that identifies the ISP server through which your
Internet connection will be routed.
Username and Password If you select PPP as the Encapsulation type, enter the username and
password you use to log in to your ISP.
Use DNS
Click Enable to turn on the DNS forwarding service, which forwards to
your LAN PCs the DNS server addresses that your PPP connection learns
from your ISP.
This option can only be used when the HM210dp/di acts as a DHCP server
for your LAN.
Primary/Secondary
DNS Server
You may just keep the default 0.0.0.0.
If you enter the Primary and Secondary DNS addresses given by your ISP,
these DNS servers will be used in addition to any DNS servers discovered
automatically.
After completing the required settings, click the
Submit
button.
Go to Admin > Commit & Reboot and click
Commit
to store your changes to
permanent memory.
