Troubleshooting
1553-CNH 160 0787 Uen PA2 2005-09-23
167
13.2
Power and Cooling Problems
If the power indicator does not turn on when the power cord is plugged in,
there may be a problem with the DC power circuit, power cord, or internal
power supply. However, if the unit powers off after running for a while,
check for loose power connections, power losses or surges from the DC
source, and verify that the unit’s cooling fans are unobstructed and running
prior to shutdown. If the problem still cannot be isolated, the internal power
supply may be defective.
13.3 Embedded
Nodes
Verify that all system components have been properly installed. If one or
more components appear to be malfunctioning (such as the power cord or
network cabling), test them in another environment where all the other
components are functioning properly
Table 23
Troubleshooting Chart
Symptom Cause
Action
ESN108 will not
start
The ESN108 HW
revision is not rec-
ognized by the
ECN.
Check from the Inventory in the Web Interface, see section
9.3 on page 45, or in CLI that the HW revision of the
ESN108 appears in the Known HW/SW relations. If not,
upgrade the EAN SW with SW that supports the ESN108
HW revision.
IP DSLAM will
not start
The IP DSLAM HW
revision is not rec-
ognized by the
ECN.
Check from the Inventory in the Web Interface, see section
9.3 on page 45, that the HW revision of the IP DSLAM ap-
pears in the Known HW/SW relations. If not, upgrade the
EAN SW with SW that supports the IP DSLAM HW revi-
sion.
Summary of Contents for ECN320
