Ericsson ECN320, User Manual

Page: 144 / 188

Command Line Interface
136
1553-CNH 160 0787 Uen PA2 2005-09-23
Default Setting
External Interface :
VLAN ID: 246
IP Address: 0.0.0.0
Subnet mask: 255.255.255.0
Internal Interface :
VLAN ID: 247
IP Address: 10.0.100.1
Subnet mask: 255.255.0.0
Untagged Interface :
VLAN ID: 248
IP Address: 10.1.100.1
Subnet mask: 255.255.255.0
Default Gateway : 0.0.0.0
Command Usage
This command is used during basic configuration, and if the IP or VLAN
properties of the ECN or the embedded elements have to be changed.
Executing interface commands will not change the settings in the ECN until
the
interface activate
command is executed. To complete the
changes the following steps must be taken:
•
HP OpenView must discover the ECN. The command
nmdemandpoll
< IP_Address of the ECN >
can be used.
•
Discover EAN in PEM by searching for the new EAN
•
Delete the ECN with the old IP address from PEM
The interfaces configured are only used for management, and are not as-
sociated with any End-user traffic.
Note that if the internal interface is changed, all embedded nodes will be
restarted automatically when
interface activate
is executed (in order
to be able to receive the new management VLAN). The ECN will always re-
start when
interface activate
is executed.
The netmask for the internal interface must be at least 255.255.0.0 or
higher (for example 255.128.0.0). Note that the Default Gateway IP ad-
dress must be within the network mask of the external interface.
The ip address for the internal interface must not be in the range reserved
for the embedded elements i.e. xxx.xxx.1.1 – xxx.xxx.99.200.