Placing An Automatically Dialed Call
Ten (10) telephone numbers can be programmed
or stored in the radio for automatic dial operation.
Typically, telephone numbers that are programmed
into the radio by the maintenance personnel each
have a specific name (8 characters maximum) as-
signed. For example: "OFFICE" or "HOME".
In System models, telephone numbers that are
stored in the radio using the numberic keypad are
named "PHONE x" (where "x" is the storage location
1 - 10) when they are stored. When stored numbers
are later recalled using the "PHONE" menu, the last
eight (8) entered digits of the number will be the name
that appears in the display.
To recall a programmed or stored number and
complete a call, proceed as follows:
1.
If the "SCN" status flag is on, press SCAN
to turn scan off.
2.
Select a channel in your radio system that
has telephone interconnect capability. The
radio should be programmed for DTMF op-
eration on this channel.
3.
If private mode is enabled ("PVT" status flag
on), press the PVT button to disable private
mode.
4.
Press the MENU button until "PHONE" ap-
pears in the display.
5.
Press the SEL button to scroll through the
phone list until the programmed or stored
name for the desired telephone number ap-
pears in the display.
6.
Press and release the PTT BUTTON to
automatically dial the selected number.
7.
When the called party answers, press the
PTT BUTTON to transmit and release it to
receive. Repeat as needed. If desired, en-
able private mode by pressing the PVT but-
ton.
8.
At the completion of the call, press the EXIT
button. The radio will then transmit the dis-
connect digit to hang-up.
25
Summary of Contents for AEGIS M-PA
Page 1: ...Operator s Manual AEGIS M PA PORTABLE RADIO LBI 38798B E...
Page 5: ...Figure 1 Aegis M PA Select Model Radio SIDE VIEW FRONT VIEW 5...
Page 6: ...Figure 2 Aegis M PA Scan Model Radio SIDE VIEW FRONT VIEW 6...
Page 7: ...Figure 3 Aegis M PA System Model Radio SIDE VIEW FRONT VIEW 7...
