© 2001 – Ericsson Amplifier Technologies Inc.
4
2. INSTALLATION
2.1 Introduction
This section contains receiving, unpacking and installation recommendations for the
Ericsson Amplifier Technologies MCPA multi-carrier power amplifier. Carefully read
and review all of the information contained in this section before attempting to install or
operate the MCPA. In addition, read and review the operating instructions contained in
Section 3 before operating the equipment.
2.2 Electrical Service Recommendations
Ericsson Amplifier Technologies strongly recommends the use of AC line conditioning
and surge suppression devices at the primary AC input to the power source for the
MCPA. All electrical connections should be in accordance with the National Electric
Code, and any applicable state and local codes. In addition, lightning protection for all
systems is strongly recommended. The electric service must be well grounded.
The amplifier power source should be equipped with a separate circuit breaker,
installed in a load center with a separate mains switch or breaker. This arrangement
permits future service and maintenance of the MCPA without the necessity for
removing power to the entire site.
2.3 Receiving, Unpacking and Inspection
The MCPA has been tested and calibrated at the factory prior to shipment. No
additional readjustment is required prior to installation.
The MCPA is shipped in a single container. Check the exterior of the shipping
container for any visible signs of damage. If possible, open the container in the
presence of the delivery agent. Carefully unpack the MCPA and save all packing
material for possible reshipment. After removal from the container, check the MCPA for
physical damage such as scratched panels, damaged connectors, etc. If damage is
noted, immediately file claim with the delivery agent or freight carrier.
2.4 Repackaging for Shipment
Should it ever become necessary to re-ship the MCPA for service or repair, the
following procedure should be followed.
a. Use the original container, if possible.
b. Wrap the item in heavy paper or plastic before placing it in the shipping container.
c. Use packing material around all sides of the item.
d. Use a heavy cardboard box or a wooden container to house the item. Seal the
container with heavy-duty tape (Fiberglas) or strap the container with metal bands.
e. Mark the container: "FRAGILE - DELICATE INSTRUMENT".
