Operating instruction
Spindle lifting system SL/SK/SM 14xx Compact
Document no.: B-00061
Edition 2022 05
Operating instruction EN
Copyright by Ergoswiss AG
Page
6
of
26
The lifting system must not be:
→
operated outside of the performance data (max. tensile, compressive, bending moment loads).
→
subjected to impulse, impact and impact forces (e.g. setting down loads).
→
operated with an incorrect mains voltage! Adhere to the type plate of the control box!
→
designed for continuous operation (below the duty cycle ratio of 2/18).
→
operated on unstable or sloping ground.
→
operated with impermissible or non-designated components.
(e.g. different types of lifting columns; replacement of the control (control software))
→
operated with damaged components.
→
opened, reworked or rebuilt.
→
operated if the power cable is not freely accessible. Disconnect the power cord in the event of a fault.
→
Children must not play with the device. Cleaning and user maintenance shall not be made by children
without supervision.
When installing and operating the lifting system, the intended use of the entire system must be adhered to.
Commissioning is prohibited until the entire system complies with the provisions of the EC Directives
2006/42/EC (Machinery Directive). For this purpose, it is essential to perform a risk analysis, so that possible
residual hazards can be reacted to (e.g. through constructive measures or through instructions in the oper-
ating instructions and/or through safety indication on the system). In the event of improper use, the liability
of Ergoswiss AG and the general operating permit for the lifting system will expire.
2.3
Target group and prior knowledge
Before installing and operating the lifting system, this operating instruction must be read and understood.
The manual must be kept in close proximity to the system for future reference.
This operating instruction addresses the following groups of people:
The
manufacturer of the overall system
who integrates this lifting system into an overall system and
integrates these operating instructions into the operating instructions for the overall system.
The
commissioning personnel
who install the lifting system in a workplace, a machine, etc. and put it
into operation. For commissioning basic mechanical and electrical knowledge are required.
