2
WEIGHT ADJUSTABLE ESPREE PNEUMATIC TABLE BASE
PARTS AND TOOLS
PLEASE REVIEW
these instructions before beginning the assembly procedures. Check that all the parts shown
below were provided with your order. Contact your supplier if any materials are missing. Do not discard the
packaging until content that the product operates to your satisfaction.
ADDITIONAL TOOLS REQUIRED
• #2 and #3 Phillips screwdriver
• Rubber mallet
•
3
/
8
" ratchet or manual driver*
PARTS AND TOOLS PROVIDED
Frame Assembly (1)
Adjustable Feet (2)
10mm Hex Bit*,
3
/
8
" Drive (1)
Allen Keys (1 each)
Cable Clip (1)
Fasteners
Top Support
End Cap (4)
5mm
6mm
CAUTION:
Hand-tighten screws only.
M8x40 SHCS (7)
M8x14 SHCS (4)
M8x25 FHCS (1)
#12x2¾ PPH (10)
Plastic Clip (8)
#8x½ PPH (5)
IMPORTANT:
The columns of this table contain high force pneumatic springs that are sized to lift the work
surface and its contents. Proper sizing, handling, and assembly is critical to prevent damage to the columns
or serious injury. All persons not involved in the installation should remain at a safe distance until set-up is
Review the lift rating decal on the frame to learn the minimum and maximum lift weight for the unit. The lift
weight is the total weight of the work surface and the contents it supports.
*DO NOT USE A POWER DRIVER WITH THE 10mm HEX BIT. THIS WILL VOID THE WARRANTY.
WARNING:
Do not activate the release lever until the table is fully assembled and
in the upright position. Do not remove any bolts or hardware from the leg columns. Do not
remove the safety pins, warning tags, and warning labels until the table is fully assembled
and in the upright position. Sudden extension of the table legs may cause serious injury if
these instructions are not followed.
CAUTION:
Always check that screws
used to attach components to the
work surface are not too long for the
thickness of the surface.
Work
Surface
Ratchet Clip (1)
Note:
If installing a keyboard tray please see page 8, step 11.
3mm
