10
WEIGHT ADJUSTABLE ESPREE PNEUMATIC TABLE BASE
ADJUSTMENT
STEP 14
Using a ratchet wrench or manual driver with the 10mm hex bit provided, adjust the pneumatic force by
turning the hex adjustment found on the side, next to the gauge.
• See the graph below right for a 48" table base. At the 0/0 gauge reading, weight is set for just under 50
lbs. That moves up slowly to about 60 lbs at the 4/0 gauge reading and then increases more rapidly, to
over 100 lbs at the 8/0 gauge reading.
Do not adjust past the 8/0 setting due to risk of damage.
• If you know the approximate weight of the table top (work surface plus contents), you can go to the
gauge reading for that weight.
• The goal in making this adjustment is to equalize the force needed to raise the table with the force
needed to lower it.
IMPORTANT:
Retain the 10mm hex bit for future adjustments. Be careful not to misplace it.
STEP 15
Adjust cable tension, if necessary.
• If the table does not lock into place when the lever is released, tighten the cable adjustment nut one-half
turn and recheck.
• If the table stays locked in one place or moves slowly, loosen the cable adjustment nut one-half turn and
recheck.
• Call ESI Customer Service if you
have questions about operation
or adjustment.
IMPORTANT:
Cable tension is
pre-adjusted at the factory.
Do not perform this adjustment
yourself unless absolutely necessary.
10mm
Hex Bit
Gauge Reading
Pounds
A setting lower than 0/0 or
higher than 8/0 is not permitted.
0
0
150.0
100.0
50.0
0.0
48" Table Base
0.
0
1.
0
2.
0
3.
0
4.
0
5.
0
6.
0
7.
0
8.
0
8mm
Wrench
